GET Engineering Logo

NTDS Over Ethernet Systems

TCP/IP products

GET Engineering MILSTD‑1397 NTDS Over Ethernet Systems transform NTDS data to standard Ethernet protocol effectively turning your NTDS ports into a NIC Card that meet stringent NTDS latency specifications. Any NTDS device can be accessed through a standard 807 Gigabit Ethernet port. GET Converters integrate legacy UYK tactical data processors and peripheral equipment into the new Net Centric “Open Architecture” standard. Hardware configurations are offered in various Rugged Enclosures and Rack Mounted 4U Chassis.

Software conforms to the standard GET Engineering driver protocol. The user configures the server software though the TCP/IP connection using the GET Common User Interface for ease in application development and porting. Multi node connectivity is through the Ethernet interface.

Key Hardware Features

  • Touch Screen Panel for adapter Status & configuration
  • Diagnostic Connector on Front Panel
  • Short Circuit protection on all Outputs
  • Field Upgradeable Firmware
  • Hot Swappable
  • Tri‑State of NTDS Interface
  • CAT 5 wire (copper) or Fiber output

Key Maintenance Features

  • Extensive Built‑In‑Test Options
  • Loop‑back through Fiber‑optic Interface
  • Loop‑back through NTDS Interface
  • Tri‑State of NTDS Interface
  • Activity LEDs to aid troubleshooting of interface
  • Diagnostic messaging over fiber optic media
Specifications
MILSTD‑1397C Interface Full Compliance to MILSTD‑1397C. Parallel Types A, B, C & H and Serial Type D & E
Fiber optic Interface Small Form‑Factor Pluggable (SFP) Multi‑Source Transceiver
Fiber optic Types Supported Multi‑mode (850 nM), Single‑mode (1310 nM)
I/O Connections: Rear Panel Parallel: UYK‑7, UYK‑43, UYK‑44, CP‑642, DD78, and DD50 (other on request)
TCP/IP speed 1.9ms Client to Server to Client loop‑back cycle time with 100 word packet on dedicated 1Gb ether link.
 
Environmental Specifications
Operating Temperature 0°C to 70°C Operating
Storage Temperature -40°C to 85°C standard (MILSTD‑810, Method 501 and 502, Procedure 1)
Humidity 5% to 95% humidity (non‑condensing) (MILSTD‑810, Method 507)
Mean Time Between Failures Greater than 200K hours MTBF per MILHDBK‑217, Revision E, 25°C Ground Benign Environment
Adapter Assemblies

Adapter Assemblies

Rugged engineering brings you reliability like no other

Learn More

NTDS Over Ethernet Systems

NTDS Over Ethernet Systems

The ability to adapt to any situation at anytime

Learn More

Fiber Optic solutions

Fiber Optic solutions

"Out of range" needn’t be in your vocabulary

Learn More

Tactical Data Processors

Tactical Data Processors

Easy connectivity enables legacy system modernization

Learn More

Cables and Connectors

Cables and Connectors

Light weight, adaptable connections for NTDS

Learn More